Each Donut Clamp Assembly supports a maximum weight of 11.5kg (25lbs)
This product suits VESA compliant displays with 75mm x 75mm (3” x 3”) and
100mm x 100mm (4” x 4”) mounting hole patterns.
The manufacturer does not accept responsibility for incorrect installation
Check you have received all parts against this component checklist prior to installation
Phillips Head Screw Driver
Attach Upright Pole to Base Install Horizontal Support and Donut Clamp
Attach the Upright Pole to the Base
as shown below. Ensure the Cable
Slot faces towards the rear.
Follow steps below to attach the Horizontal Support and Donut Clamp
assembly onto the Upright Pole. Ensure the Cable Slots in all the Poles are
facing to the rear.
Slide the Horizontal Support
to desired position
Repeat steps B.1, B.2 and B.3
for the 2nd set of Horizontal
Support and Donut Clamp
Loosen the Hex screws in the
Horizontal Support Donut using
the supplied 5mm Allen Key
Tighten supports firmly
using the supplied 5mm
5mm Allen Key
When tightening the Donut Clamp,
each of the Donut bolts must be
tightened evenly, as failure to do so
will damage the Donut Clamp. Do
not over-tighten as this may also result
Number of questions: 0
Do you have a question about the Atdec V-FS-Q or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Atdec V-FS-Q owners to properly answer your question.
About the Atdec V-FS-Q
View the manual for the Atdec V-FS-Q here, for free. This manual comes under the category Flat panel support and has been rated by 1 people with an average of a 9.1. This manual is available in the following languages: English. Do you have a question about the Atdec V-FS-Q or do you need help? Ask your question here