Dayton Audio APA150 manual

Dayton Audio APA150
(1)
  • Number of pages: 2
  • Filetype: PDF

150 Watt Audio Amplifier

© 2007 Dayton Audio
®
Dayton Audio
©
PO Box 52
Springboro, Ohio 45066
300T812

APA150

Specifications:
Power Output: 75 watts RMS x 2 into 4 Ω
150 watts RMS x 1 into 8
Ω
Total Harmonic Distortion: Less than 0.01%
(20-20,000 Hz)
Signal-to-Noise Ratio: >100 dB, unweighted
Crossover: Variable 50-150 Hz,
18 dB/octave
Auto-On Sensitivity: 3 mV
Auto-Off Delay Time: 15 minutes
Input Impedance: 47 k Ω ±5%
Line-Out Frequency Response: 20-20,000 Hz (-3 dB)
Maximum Noise and Hum: Less than 1 mV with gain at maximum
and input shorted
Minimum Clearance for Ventilation: 2”
Electrical Requirement: 120V 60 Hz, 230V 50 Hz (switchable)
Dimensions: 5.6” H x 5.7” W x 12.8” D
Weight: 11.05 lbs

Warranty

The Dayton Audio APA150 warranted free from defects in material and
workmanship for one year from date of purchase. Warranty does not apply
to misuse, abuse, neglect, accident, improper use, etc.
Notes About Hum
The addition of a new component to an existing system can sometimes result in an
audible hum. While it would be easy to assume that the new product is at fault or even
defective, it is usually just an indicator that it is time to take a closer look at the overall
grounding of the audio system. To start with, verify that all audio equipment is on the
same AC power circuit. The outlets in an area may or may not all be on the same breaker.
Always make sure that all equipment grounds are in good condition, and NEVER remove
the ground pin from a power plug. There are some cases where the actual power line has
some form of interference, but the most common cause of noise is a ground loop. The
cable TV line can be the cause of hum in multi-source home audio/video systems. Just
temporarily disconnect the cable line, and if the hum stops then the use of an inline isola-
tion transformer is suggested. The key is to proceed slowly and step by step, taking care
to identify which cables or combinations of cables cause noise when connected.
Dayton Audio APA150

Need help?

Number of questions: 0

Do you have a question about the Dayton Audio APA150 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Dayton Audio APA150 owners to properly answer your question.

View the manual for the Dayton Audio APA150 here, for free. This manual comes under the category Receivers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Dayton Audio APA150 or do you need help? Ask your question here

Dayton Audio APA150 specifications

General
Brand Dayton Audio
Model APA150
Product Receiver
EAN 0844632061523
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Dayton Audio APA150.

Is your question not listed? Ask your question here