For assistance, please call: 1-800-211-PANA(7262)For assistance, please call: 1-800-211-PANA(7262)
1 Getting Started
1-A Location of controls
4 Things You Should Know
4-A Wall Mounting
($) (TONE) Button (3-B)
(REDIAL) Button (2-A)
DIALING MODE Selector
VOLUME (^), (_)
1Connect the telephone line cord (1).
2Connect the handset cord (2), then conﬁrm
the dial tone.
Telephone Jack (RJ11C)
Telephone Line Cord
1 When the unit rings, lift the handset.
2 When ﬁnished talking, hang up.
3 Set the DIALING MODE selector to TONE.
≥If you cannot dial, set to PULSE.
4 Set the RINGER selector to HIGH, LOW or
(Ex. “LOW” is selected.)
2-A Making Calls
2-B Answering Calls
Lift the handset.
2 Dial a phone number.
≥If you misdial, hang up and start again from
3 When ﬁnished talking, hang up.
To redial the last number dialed
Lift the handset.
➡ Press (REDIAL).
To adjust the receiver volume (6 levels)
To increase, press
To decrease, press (_).
≥After hanging up, the volume level will be saved.
2 Operation 3 Special Features
3-A For Call Waiting Service Users
Press (FLASH) if you hear a call-waiting tone
≥The ﬁrst call is put on hold and you can answer the
≥To return to the ﬁrst caller, press (FLASH) again.
3-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press ($) (TONE) before entering access
numbers which require tone dialing.
≥The dialing mode changes to tone. You can enter
numbers to access answering services, electronic
banking services, etc. When you hang up, the
mode will return to pulse.
≥Access numbers entered after pressing ($)
(TONE) will not be included when redialing.
The unit can be mounted on a wall phone plate.
1 Press the tabs in the direction of the arrows
(1), then remove the wall mounting adaptor
≥Environment—do not place the unit in a room
where the temperature is less than 5oC (41oF) or
greater than 40oC (104oF). Allow 10 cm (4z)
clearance around the unit for proper ventilation.
Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
≥Routine care—wipe the unit with a soft cloth. Do
not use benzine, thinner, or any abrasive powder.
≥If there is any trouble—disconnect the unit from
the telephone line and connect a known working
phone. If the known working phone operates
properly, have your unit repaired by one of the
authorized Panasonic Factory Service Centers. If
the known working phone does not operate
properly, consult your telephone company.
Printed in USA
PQQX13857YA F0703-1073 D
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial
Park Carolina, Puerto Rico 00985
For your future reference
(found on the bottom of the unit)
Date of purchase
Name and address of dealer
Integrated Telephone System
Model No. KX-TS500B
Pulse-or-tone dialing capability
PLEASE READ BEFORE USE AND SAVE.
∑Handset. . . . . . . one
∑ Handset Cord. . . one
∑Telephone Line Cord
. . . . . . . . . . . . . one
4-C Helpful Information
≥When set to OFF, the unit will not ring.
3 Connect the telephone line cord. Mount the
unit, then slide down.
≥Fasten the cord to prevent it from being
2 Tuck the telephone line cord inside the wall
mounting adaptor, and push it in the
direction of the arrow (1and 2).
≥The word “UP WALL” should face upward.
Power Source:From telephone line
Dimensions (H x W x D):
Approx. 96 mm x 150 mm x 200 mm
q k 5
Mass (Weight):Approx. 475 g (1.05 lb.)
Dialing Mode:Tone (DTMF)/Pulse
Operating Environment: 5°C – 40°C (41oF – 104oF)
Speciﬁcations are subject to change without notice.
Attach your purchase receipt here.
If you need assistance with the set-up or
please call 1-800-211-PANA(7262)
≥For extra orders, call
Panasonic World Wide Web:
for customers in the USA or Puerto Rico
For product service
≥Call 1-800-211-PANA(7262) or 1-800-833-9626 for
the location of an authorized servicenter.
≥Panasonic’s e-mail address for customer inquiries:
for customers in the USA or Puerto Rico ONLY
The unit does
The call cannot
even if you
The unit does
If you cannot
≥Check the settings (1-B).
≥Check whether the DIALING
MODE selector setting is
correct or not (1-B).
≥The RINGER selector is set
to OFF. Set to HIGH or LOW
≥Call our customer call center
≥Panasonic’s e-mail address
for customer inquiries:
for customers in the USA or
Puerto Rico ONLY
When you ship the product
≥Carefully pack your unit, preferably in the original
≥Attach a letter, detailing the symptom, to the outside
of the carton.
≥Send the unit to an authorized servicenter, prepaid and
≥Do not send your unit to the Panasonic Consumer
Electronics Company listed on the back cover or to
executive or regional sales offices.
These locations do not repair consumer products.
To temporarily set the
handset down during
a conversation, place
it as shown here.
PQQX13857YA 03.7.30 2:49 PM ページ 1
Number of questions: 0
Do you have a question about the Panasonic KX-TS500B or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Panasonic KX-TS500B owners to properly answer your question.
View the manual for the Panasonic KX-TS500B here, for free. This manual comes under the category DECT / VoIP phones and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Panasonic KX-TS500B or do you need help? Ask your question here